June 05, 2008

Multi-Connection Router - LinkSys RV042

I have had both cable modem and DSL now for a long time and intend to keep both. I do so much work from home - that I cannot afford the 2-3% outage that my cable modem seems to have. So I added the second cheapest DSL from ATT as a backup. It does give me free ATT WiFi in a few airports for free.

Up til now, I have been just going downstairs and switching cables when one r the other service went down - or just used the slower DSL all the time.

But thanks to Bryan Holland I found a LinkSys RV042 router that does a dual network connection for the home.

It installs pretty easily. Initially it only uses one link and uses the other as backup. SO I switched it to load balancing - this was very cool - except little things did not work. Mostly YouTube messes up - my guess is that it gets two IPs on successive requests and decides a session has been stolen and zaps you :( My guess is that hyper sensitive software will do the same.

So I go back to the failover mode by default - at least my family does not have to switch the wires while I am traveling. It is simple enough to switch back and forth.

If I am going to do a lot of uploads or downloads, I temporarily turn on load balancing and then turn it back off when my need for bandwidth is back to normal.

It was pretty reasonably priced.

Review: LinkSys RV042

P.S. I typed this entire post waiting for my fresh checkout of Sakai's trunk to recompile. Actually while waiting for the compile - I went to get a cup of coffee, talked to my daughter for a few minutes - and *then* typed this blog post. Well - got to run - the compile is *almost* done - it is compiling sakai-reset-pass

Posted by csev at June 5, 2008 11:06 AM